Debug Ip Bgp Keepalives - Dell S6000 Reference Manual

Parameters
ip-address
peer-group
peer-group-
name
in
out
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
To remove all configured debug commands for BGP, enter the no debug ip bgp
Information
command.

debug ip bgp keepalives

Display information about BGP keepalive messages.
S6000
Syntax
debug ip bgp [ip-address | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ip-address
354
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
(OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
(OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
(OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
Border Gateway Protocol