Match Ip Next-Hop - Dell S4810 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Related
match interface
Commands

match ip next-hop

match ip route-source
routers.
match metric
match route-type
match tag
match ip next-hop
To match based on the next-hop IP addresses specified in an IP access list or IP prefix list, configure a
filter.
S4810
Syntax
match ip next-hop {prefix-list prefix-list-name}
To delete a match, use the no match ip next-hop {prefix-list prefix-
list-name} command.
Parameters
prefix-list
prefix-list-
name
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Access Control Lists (ACL)
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— redistributes routes that match the next-hop interface.
— redistributes routes that match the next-hop IP address.
— redistributes routes that match routes advertised by other
— redistributes routes that match a specific metric.
— redistributes routes that match a route type.
— redistributes routes that match a specific tag.
Enter the keywords prefix-list and then enter the name
of configured prefix list, up 10 140 characters.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
275