Dot1X Timeout Tx-Period - Dell Networking 2024 Reference Manual

Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The actual timeout is this parameter or the product of the Radius
transmission times the Radius timeout, whichever is smaller.
Example
The following example sets the time for the retransmission to the
authentication server to 3600 seconds.
console(config-if-1/0/1)# dot1x timeout server-timeout 3600

dot1x timeout tx-period

Use the dot1x timeout tx-period command in Interface Configuration mode
to set the number of seconds that the switch waits for a response to an
Extensible Authentication Protocol (EAP)-request/identity frame from the
client before resending the request. To return to the default setting, use the
no form of this command.
Syntax
dot1x timeout tx-period
no dot1x timeout tx-period
seconds — Time in seconds that the switch should wait for a response to
•
an EAP-request/identity frame from the client before resending the
request. (Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
seconds
802.1x Commands
857