Dot1X Supplicant-Timeout - Dell S4810 Reference Manual

Where the default values are as follows: dot1x server-timeout (30 seconds),
radius-server retransmit (3 seconds), and radius-server timeout (5 seconds).
For example:
Dell(conf)#radius-server host 10.11.197.105 timeout 6
Dell(conf)#radius-server host 10.11.197.105 retransmit 4
Dell(conf)#interface gigabitethernet 2/23
Dell(conf-if-gi-2/23)#dot1x server-timeout 40

dot1x supplicant-timeout

Configure the amount of time after which exchanges with the supplicant time-out.
S4810
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
Parameters
seconds
Defaults 30 seconds
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version
8.3.12.0
Version 8.3.11.1
Version 7.6.1.0
Version 7.4.1.0
198
Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
802.1X