Data (Export) - Keysight x-series User Reference Manual

12 Disturbance Analyzer Measurement
Save
There is one set of 128 state registers in the instrument, not one set for each Mode. When a state is saved,
the Mode it was saved from is saved with it; then when it is recalled, the instrument switches to that Mode.
After the save completes, the corresponding register menu key annotation is updated with the date and
time and the message "Register <register number> saved" is displayed.
Key Path
Mode
Example
Range
Readback
Initial S/W Revision
Modified at S/W Revision

Data (Export)

Exporting a data file stores data from the current measurement to mass storage files. The Export Menu
only contains data types that are supported by the current measurement.
Since the commonly exported data files are in .csv format, the data can be edited by you prior to importing.
This allows youto export a data file, manipulate the data in Excel (the most common PC Application for
manipulating .csv files) and then import it.
Selecting an Export Data menu key will not actually cause the exporting to occur, since the analyzer still
needs to know where you wish to save the data. Pressing the Save As key in this menu brings up the Save
As dialog and Save As menu that allows you to specify the destination file and directory. Once a filename
has been selected or entered in the Open menu, the export will occur as soon as the Save key is pressed.
Key Path
Mode
Notes
Dependencies
Preset
Readback
Initial S/W Revision
1100
Save, State
All
*SAV 1
1–16 from front panel, 1–128 from SCPI
Date and time with seconds resolution are displayed on the key
OR
A custom name of up to 30 characters entered using the Edit Register Names key
OR
"(empty)" if no prior save operation has been performed to this register.
Prior to A.02.00
A.11.00
Save
All
The menu is built from whatever data types are available for the mode. So the key locations in the
sub menu will vary.
No SCPI command directly controls the Data Type that this key controls. The Data Type is included in
the MMEM:STORe commands.
If a file type is not used by a certain measurement, that type is grayed out for that measurement. The
key for a file type will not show at all if there are no measurements in the Mode that support it.
Is not affected by a Preset or shutdown, but is reset during Restore Mode Defaults
The data type that is currently selected
Prior to A.02.00
EMI Receiver Mode Reference