Table of Contents
Advertisement
5
Recovery
Restoring from an image
Restoring from a previously captured image
Step
1 Make sure the computer is turned off.
2 Turn on the computer.
3 Press the down arrow key to move the highlight to
4 At the command prompt, press 2 for the command
5 Type
6 Type
Changing the default restore image
When you select
drive will be reformatted and the contents of the image at
e5500cpart.wim
To change the default image used by the Agilent Recovery system, rename
Agilent\Images\e5500cpart.wim
e5500cpart-factory.wim
Images
Agilent Recovery system; however changing the default restore image can be done from
Windows.
74
Agilent Recovery System, then press Enter.
shell.
format C: /FS:NTFS /Q /V:SYSTEM
then press the Enter key.
/Y
imagex /apply "D:\imageName.wim"
then press the Enter key.
1 C: /verify
to start the recovery process within Agilent's recovery system, the C
1
will be extracted into the newly formatted partition.
and rename it
e5500cpart.wim
Notes
The following screen is displayed:
•
Reformats the C: partition thus
destroying every file on it.
•
Extracts the contents of the image
file, in this case D:\
imageName.wim, onto the C
partition.
to
F:\Agilent\Images\
. Then move your desired image into
. The image must be created from within the
F:\Agilent\Images\
F:\
F:\Agilent\
E5505A Installation Guide
Advertisement
Table of Contents
