To 199, Measurement Integrity - Keysight X-Series Manual

Instrument Messages
Condition Messages
Err# Bit in Message
status
register
69 1
Align 30MHz to 1GHz
failed
71 2
Characterize Preselector
failure
73 3 unused
75 4 unused
77 5 unused
79 6
Align Source IQ failed
81 7
Align Source RF failed
83 8
MPA Align failed
85 9 unused
87 10 unused
89 11 unused
91 12 unused
93 13 unused
95 14 unused

101 to 199, Measurement Integrity

This series of errors corresponds to the bits in the
STATus:QUEStionable:INTegrity
System" on page
corresponding bit in that register.
An event with the number shown in the table means the condition has been
detected. When the condition is cleared, an event with the number plus 1000
is generated. These error numbers can be viewed in the Show Errors screen,
along with the DETECTED and CLEARED indicators.
For example, error 141 indicates an Input Overload condition has been
detected, error 1141 indicates that failure has been cleared.
Two bits in this register are "summary bits" for registers at a lower level. There
are no error messages associated with these bits; they exist only as status bits,
which can be read with a
STATus:QUEStionable:INTegrity:CONDition?
Instrument Messages
Error or
Warning
W
W
W
W
W
register (see
116). The second column in the table shows the
STATus:QUEStionable:INTegrity?
More Information
On PSA, this was error 13751
The preselector characterization routine failed.
The alignment of the built-in source IQ section
failed (products with built-in sources only)
The alignment of the built-in source RF
section failed (products with built-in sources
only)
Multiport adapter alignment failed, EXT only
"X-Series Status Register
event query or a
query.
92