Lldp Transmit - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Parameters
port-description
system-capabilities
system-description
system-name
Default
No optional 802.1AB basic management TLV is selected.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is available for physical port configuration. This command is used to select the optional
TLVs to be transmitted. If the optional TLVs advertisement is selected, they will be encapsulated in the
LLDPDU and sent to other devices.
Example
This example shows how to enable all supported optional 802.1AB basic management TLVs.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp tlv-select
Switch(config-if)#
This example shows how to enable advertising the system name TLV.
Switch# configure terminal
Switch(config)# interface ethernet 1/0/1
Switch(config-if)# lldp tlv-select system-name
Switch(config-if)#
58-15

lldp transmit

This command is used to enable the LLDP advertise (transmit) capability. Use the no form of this
command to disable LLDP transmission.
lldp transmit
no lldp transmit
(Optional) Specifies the port description TLV to send. The port
description TLV allows network management to advertise the IEEE
802 LAN station's port description.
(Optional) Specifies the system capabilities TLV to send. The system
capabilities field will contain a bit-map of the capabilities that defines
the primary functions of the system.
(Optional) Specifies the system description TLV to send. The system
description should include the full name and version identification of
the system's hardware type, software operating system, and
networking software.
(Optional) Specifies the system name TLV to send. The system name
should be the system's fully qualified domain name.
656