Lldp > Lldp Global Settings - D-Link DES-1210/ME Series Manual

4 Configuration
Profile ID: The pre-configured Profile ID for which to configure the Flow Metering parameter.
Access ID (1-128): The pre-configured Access ID for which to configure the Flow Metering parameters.
Enter the appropriate information and click Find the entries will be displayed on the lower half of the table.
To edit and entry click the corresponding Modify button, to delete an entry click the corresponding Delete
button, to add a new entry click the Add button which will display the following window for the user to
configure.
Profile ID (1-10): Specify the profile ID.
Access ID (1-128): Specify the Access ID that will be used to configure the Flow Metering parameters, enter
a value between 1 and 128.
Mode: To be used the corresponding information.
- Rate: Specify the committed information Rate of the packet. The range is from 64 to 1024000
kbyte.
- Burst Size: Specify the c
- ommitted Burst Size of the packet. The range is from 0 to 1016 kbyte.
Rate Exceed: Specifies the action when the packet is in yellow color mode.
- Drop Packet: Drops the packet.
- Replace DSCP: Allow user to change the DSCP of the packet.
Click Apply to implement changes made.
LLDP > LLDP Global Settings
LLDP (Link Layer Discovery Protocol) provides IEEE 802.1AB standards-based method for switches to
advertise themselves to neighbor devices, as well as to learn about neighbor LLDP devices. The switch will
keep the information in the Management Information Base (MIB). SNMP utilities can learn the network
topology by obtaining the MIB information in each LLDP device. The LLDP function is enabled by default.
DES-1210/ME Series Metro Ethernet Managed Switch User Manual
Figure 4.195 - ACL > ACL Flow Meter
Figure 4.196 - ACL > Add ACL Flow Meter
120