Dynamic Limit Maximum dynamically allocated MAC Addresses.
Static Limit
Violation Trap Mode Whether violation traps are enabled.
show port-security dynamic
This command displays the dynamically locked MAC addresses for the port.
Format
Mode
MAC Address MAC Address of dynamically locked MAC.
show port-security static
This command displays the statically locked MAC addresses for port.
Format
Mode
MAC Address MAC Address of statically locked MAC.
show port-security violation
This command displays the source MAC address of the last packet discarded on a locked port.
Format
Mode
MAC Address MAC Address of discarded packet on locked port.
LLDP (802.1AB) Commands
This section describes the command you use to configure Link Layer Discovery Protocol
(LLDP), which is defined in the IEEE 802.1AB specification. LLDP allows stations on an 802
LAN to advertise major capabilities and physical descriptions. The advertisements allow a
network management system (NMS) to access and display this information.
lldp transmit
Use this command to enable the LLDP advertise capability.
Default
Format
Mode
no lldp transmit
Use this command to return the local data transmission capability to the default.
Maximum statically allocated MAC Addresses.
show port-security dynamic <slot/port>
Privileged EXEC
show port-security static <slot/port>
Privileged EXEC
show port-security violation <slot/port>
Privileged EXEC
disabled
lldp transmit
Interface Config
2 Switching Commands
LLDP (802.1AB) Commands
105