Router Ospf - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set

router ospf

Use the router ospf command to activate OSPF in the router and to enter the OSPF Configuration mode.
See the section Router (OSPF) Configuration Command Set on page 1360 for more information. Use the
no form of this command to disable OSPF routing.
Syntax Description
No subcommands.
Default Values
By default, OSPF is disabled.
Functional Notes
The SROS can be configured to use OSPF with the firewall enabled (using the ip firewall command). To
do this, configure the OSPF networks as usual, specifying which networks the system will listen for and
broadcast OSPF packets to. See ip firewall on page 394 for more information.
To apply stateful inspection to packets coming into the system, create a policy-class that describes the type
ip policy-class
of action desired and then associate that policy-class to the particular interface (see
<policyname>
on page 426). The firewall is intelligent and will only allow OSPF packets that were
received on an OSPF configured interface. No modification to the policy-class is required to allow OSPF
packets into the system.
Usage Examples
The following example uses the router ospf command to enter the OSPF Configuration mode:
ProCurve(config)#router ospf
ProCurve(config-ospf)#
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 492