HP ProCurve 7102dl Reference Manual page 71

SROS Command Line Interface Reference Guide Enable Mode Command Set
The following example creates a copy of the file myfile.biz (located on the compact flash card), names the
new file newfile.biz, and places the new file on the installed compact flash card:
ProCurve>enable
ProCurve#copy cflash myfile.biz cflash newfile.biz
The following example replaces the startup configuration file with the file newconfig.txt.
ProCurve>enable
ProCurve#copy cflash newconfig.txt startup-config
The following example copies the file myfile.biz (located on the compact flash card) to the specified TFTP
server:
ProCurve>enable
ProCurve#copy cflash tftp
Address of remote host?10.200.2.4
Source filename myfile.biz
Destination filename myfile.biz
Initiating TFTP transfer...
Received 45647 bytes.
Transfer Complete!
The following example copies the file myfile.biz (located on the compact flash card) to the connected
terminal using XMODEM protocol:
ProCurve>enable
ProCurve#copy cflash xmodem
Source filename myfile.biz
Begin the Xmodem transfer now...
Press CTRL+X twice to cancel
CCCCCC
The SROS is now ready to transmit the file on the CONSOLE port (using the XMODEM protocol). The next
step in the process may differ depending on the type of terminal emulation software you are using. For
HyperTerminal, you will now select Transfer > Receive File and select the destination. Once the transfer
is complete, information similar to the following is displayed:
Received 231424 bytes.
Transfer complete
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 69