HP ProCurve 7102dl Reference Manual page 449

SROS Command Line Interface Reference Guide Global Configuration Mode Command Set
ip snmp agent
Use the ip snmp agent command to enable the Simple Network Management Protocol (SNMP) agent.
Syntax Description
No subcommands.
Default Values
By default, the SNMP agent is disabled.
Functional Notes
Allows a MIB browser to access standard MIBs within the product. This also allows the product to send
traps to a trap management station.
Usage Examples
The following example enables the IP SNMP agent:
ProCurve(config)#ip snmp agent
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 447