HP ProCurve 7102dl Reference Manual page 748

SROS Command Line Interface Reference Guide
ip access-group <listname> [in | out]
Use the ip access-group command to create an access list to be used for packets transmitted on or received
from the specified interface. Use the no form of this command to disable this type of control.
Syntax Description
listname
in
out
Default Values
By default, these commands are disabled.
Functional Notes
When this command is enabled, the IP destination address of each packet must be validated before being
passed through to the router system. If the packet is not acceptable per these settings, it is dropped.
Usage Examples
The following example sets up the router to only allow Telnet traffic into the ATM sub-interface:
ProCurve(config)#ip access-list extended TelnetOnly
ProCurve(config-ext-nacl)#permit tcp any any eq telnet
ProCurve(config-ext-nacl)#interface atm 1.1
ProCurve(config-atm 1.1)#ip access-group TelnetOnly in
5991-2114
Specifies the assigned IP access list name.
Enables access control on packets received on the specified interface.
Enables access control on packets transmitted on the specified interface.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
746