HP ProCurve 7102dl Reference Manual page 509

SROS Command Line Interface Reference Guide
snmp-server host
Use the snmp-server host command to configure the host to receive Simple Network Management
Protocol (SNMP) notifications. Use the no form of this command to remove a specified host. Variations of
this command include the following:
snmp-server host <ip address> informs version 1 <community>
snmp-server host <ip address> informs version 1 <community> snmp
snmp-server host <ip address> informs version 2c <community>
snmp-server host <ip address> informs version 2c <community> snmp
snmp-server host <ip address> informs version 3 auth <community>
snmp-server host <ip address> informs version 3 auth <community> snmp
snmp-server host <ip address> informs version 3 noauth <community>
snmp-server host <ip address> informs version 3 noauth <community> snmp
snmp-server host <ip address> informs version 3 priv <community>
snmp-server host <ip address> informs version 3 priv <community> snmp
snmp-server host <ip address> traps <community>
snmp-server host <ip address> traps version 1 <community>
snmp-server host <ip address> traps version 1 <community> snmp
snmp-server host <ip address> traps version 2c <community>
snmp-server host <ip address> traps version 2c <community> snmp
snmp-server host <ip address> traps version 3 auth <community>
snmp-server host <ip address> traps version 3 auth <community> snmp
snmp-server host <ip address> traps version 3 noauth <community>
snmp-server host <ip address> traps version 3 noauth <community> snmp
snmp-server host <ip address> traps version 3 priv <community>
snmp-server host <ip address> traps version 3 priv <community> snmp
Syntax Description
<ip address>
informs
<community>
traps
5991-2114
Specifies the IP address of the SNMP host that receives the SNMP
information. IP addresses should be expressed in dotted decimal notation
(for example, 10.10.10.1).
Enables informs to this host.
The following traps are supported:
coldStart
warmStart
linkUp
linkDown
authenticationFailure
Specifies the community string (used as a password) (16 characters
maximum) for authorized agents to obtain access to SNMP information.
Enables traps to this host. If the version is not specified, version 1 is used.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
507