HP ProCurve 7102dl Reference Manual page 68

SROS Command Line Interface Reference Guide
configure
Use the configure command to enter the Global Configuration mode or to configure the system from
memory. See Global Configuration Mode Command Set on page 299 for more information.
Syntax Description
terminal
memory
network
overwrite-network
Default Values
No default value necessary for this command.
Usage Examples
The following example enters the Global Configuration mode from the Enable Command mode:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#
5991-2114
Enters the Global Configuration mode.
Configures the active system with the commands located in the default
configuration file stored in flash memory.
Configures the system from a TFTP network host.
Overwrites flash memory from a TFTP network host.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
66