HP ProCurve 7102dl Reference Manual page 576

SROS Command Line Interface Reference Guide
training-mode
Use the training-mode command to configure the ADSL training mode. Use the no form of these
commands to disable a specific training mode. Variations of this command include:
training-mode ADSL2
training-mode ADSL2+
training-mode ADSL2+ANNEX-M
training-mode G.DMT
training-mode G.LITE
training-mode Multi-Mode
training-mode READSL2
training-mode T1.413
Syntax Description
ADSL2
ADSL2+
ADSL2+ANNEX-M
G.DMT
G.LITE
Multi-Mode
READLS2
T1.413
Default Values
By default, the training mode is set to Multi-Mode.
Functional Notes
Some of the listed training modes (G.LITE, T1.413, ADSL2, ADSL2+, READSL2) are currently supported
for ADSL over POTS (Annex A) and are not valid for ADSL over ISDN (Annex B) modules.
Usage Examples
The following example sets the training mode to T1.413:
ProCurve(config)#interface adsl 1/1
ProCurve(config-adsl 1/1)#training-mode T1.413
5991-2114
Specifies ITU G.992.3 Annex A mode.
Specifies ITU G.992.5 ADSL2+ mode.
Specifies ITU G.992.5 Annex M ADSL2+ mode.
Specifies ANSI full-rate mode.
Specifies ANSI splitterless mode.
Specifies auto detect mode. When set to multi-mode, the ADSL interface
attempts to train to the DSLAM using each of the supported training modes
until a match is found.
Specifies ITU G.992.3 Annex L mode.
Specifies ANSI T1.413 mode.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
ADSL Interface Config Command Set
574