Global Configuration Mode Command Set - HP ProCurve 7102dl Reference Manual
Secure router sros command line interface
Hide thumbs
Also See for ProCurve 7102dl:
- Configuration manual (1114 pages) ,
- Product end-of-life disassembly instructions (2 pages) ,
- Advanced management and configuration manual (1005 pages)
Table of Contents
Advertisement
SROS Command Line Interface Reference Guide
G
C
LOBAL
ONFIGURATION
To activate the Global Configuration mode, enter the configuration command at the Enable security mode
prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
do
on page 1435
end
on page 1436
exit
on page 1437
ping <address>
on page 1438
All other commands for this command set are described in this section in alphabetical order.
aaa accounting commands
aaa authentication commands
aaa authorization commands
boot system [cflash | flash] <filename> [no-backup | [cflash | flash] <backup filename>] [verify]
page 329
clock timezone <text>
crypto commands
begin on page 337
5991-2114
M
ODE
begin on page 302
begin on page 310
begin on page 316
on page 323
on page 324
on page 330
on page 334
on page 335
on page 354
on page 355
on page 359
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
C
S
OMMAND
on page 327
on page 333
on page 357
ET
on page 1431
on page 328
on page 353
on
299
Advertisement
Chapters
Table of Contents
