SROS Command Line Interface Reference Guide
Demand Interface Configuration Command Set
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value>
Specifies the bandwidth value in kbps.
Default Values
To view default values, use the show interfaces command.
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets the bandwidth of the demand interface to 10 Mbps:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#bandwidth 10000
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
820