HP ProCurve 7102dl Reference Manual page 420

SROS Command Line Interface Reference Guide
ip host <name> <address>
Use the ip host command to define an IP host name. This allows you to statically map host names and
addresses in the host cache. Use the no form of this command to remove defined maps.
Syntax Description
<name>
<address>
Default Values
By default, the host table is empty.
Functional Notes
The name may be any combination of numbers and letters as long as it is not a valid IP address or does
not exceed 256 characters.
Usage Examples
The following example defines two static mappings:
ProCurve(config)#ip host mac 10.2.0.2
ProCurve(config)#ip host dal 172.38.7.12
5991-2114
Name of the host.
IP address associated with this IP host.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
418