HP ProCurve 7102dl Reference Manual page 94

SROS Command Line Interface Reference Guide
debug dialup-interfaces
Use the debug dialup-interfaces command to generate debug messages used to aid in troubleshooting
problems with all dialup interfaces such as the modem or the BRI cards. Use the no version of this
command to disable it.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
No subcommands.
Default Values
By default, all debug messages in the SROS are disabled.
Functional Notes
When enabled, these messages provide status information on incoming calls, dialing and answering
progress, etc. These messages also give information on why certain calls are dropped or rejected. It is
beneficial to use this command when troubleshooting backup (in addition to the debug backup
command).
Usage Examples
The following example activates the debug messages for dialup interfaces:
ProCurve>enable
ProCurve#debug dialup-interfaces
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
92