HP ProCurve 7102dl Reference Manual page 389

SROS Command Line Interface Reference Guide
ip dhcp-server excluded-address <start ip> <end ip>
Use the ip dhcp-server excluded-address command to specify IP addresses that cannot be assigned to
DHCP clients. Use the no form of this command to remove a configured IP address restriction.
Syntax Description
<start ip>
<end ip>
Default Values
By default, there are no excluded IP addresses.
Functional Notes
The SROS DHCP server (by default) allows all IP addresses for the DHCP pool to be assigned to
requesting clients. This command is used to ensure that the specified address is never assigned by the
DHCP server. When static addressed hosts are present in the network, it is helpful to exclude the IP
addresses of the host from the DHCP IP address pool. This will avoid IP address overlap.
Usage Examples
The following example excludes an IP address of 172.22.5.100 and the range 172.22.5.200 through
172.22.5.250:
ProCurve(config)#ip dhcp-server excluded-address 172.22.5.100
ProCurve(config)#ip dhcp-server excluded-address 172.22.5.200 172.22.5.250
5991-2114
Specifies the lowest IP address (using dotted decimal notation) in the range OR a
single IP address to be excluded.
Optional. Specifies the highest IP address (using dotted decimal notation) in the
range. This field is not required when specifying a single IP address.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
387