HP ProCurve 7102dl Reference Manual page 219

SROS Command Line Interface Reference Guide
show ip mroute [<group-address> | <interface>] [summary | all]
Use the show ip mroute command to display IP multicasting routing table information.
Syntax Description
<group-address>
<interface>
summary
all
Default Values
No default value necessary for this command.
Usage Examples
The following is sample output from this command:
ProCurve>enable
ProCurve#show ip mroute
IP Multicast Routing Table
Timers: Uptime/Expires
(*, 10.2.170.3), 01:03:19/00:00:00
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
fr 1.20, Forward, 01:03:19/00:01:48
(*, 10.1.1.1), 00:00:01/00:02:58, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list: <-- because lo 100 ifc is joined
Loopback100, Forward/Dense, 00:00:01/00:00:00
(*, 10.0.1.50), 00:00:01/00:02:58, RP 0.0.0.0, flags: DCL
Incoming interface: Null, RPF nbr 0.0.0.0
Outgoing interface list:
Loopback100, Forward/Dense, 00:00:01/00:00:00
5991-2114
Optional. Displays IP address of a multicast group.
Optional. Designates the display of parameters for a specific interface (in the format
type slot/port). For example: eth 0/1.
Optional. Displays a single-line summary for each entry in the IP multicast routing
table.
Optional: Displays all multicast routes, including those not used to forward
multicast traffic.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
217