HP ProCurve 7102dl Reference Manual page 136

SROS Command Line Interface Reference Guide
debug ppp
Use the debug ppp command to activate debug messages associated with point-to-point protocol (PPP)
operation in the SROS. Debug messages are displayed (real-time) to the terminal (or Telnet) screen. Use
the no form of this command to disable the debug messages. Variations of this command include:
debug ppp authentication
debug ppp errors
debug ppp negotiation
debug ppp verbose
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
authentication
errors
negotiation
verbose
Default Values
By default, all debug messages in the SROS are disabled.
Functional Notes
The debug ppp command activates debug messages to provide information on PPP activity in the system.
PPP debug messages can be used to aid in troubleshooting PPP links.
Usage Examples
The following example activates debug messages associated with PPP authentication activity:
ProCurve>enable
ProCurve#debug ppp authentication
5991-2114
Activates debug messages pertaining to PPP authentication (CHAP, PAP, EAP,
etc.).
Activates debug messages that indicate a PPP error was detected (mismatch in
negotiation authentication, etc.).
Activates debug messages associated with PPP negotiation.
Activates detailed debug messages for PPP operation.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
134