HP ProCurve 7102dl Reference Manual page 69

SROS Command Line Interface Reference Guide
copy [cflash | flash] <filename> boot
Use the copy boot commands to copy the specified file (located in flash memory or on the compact flash
card) to the Boot ROM.
Syntax Description
cflash
flash
<filename>
boot
Default Values
No default value necessary for this command.
Functional Notes
Updates to the Boot ROM are required periodically to enhance and expand the router's operation. The
Boot Code can now be updated from within the Command Line Interface (CLI) (beginning with software
release J03.01) using the copy boot command.
Usage Examples
The following example copies the file J03_01-boot.biz (located on the compact flash card) to the
Boot ROM:
ProCurve>enable
ProCurve#copy cflash J03_01-boot.biz boot
Upgrading boot code is a critical process that cannot be interrupted. If
something were to happen and the process was not able to be completed, it
would render your unit inoperable. It is for this reason that during a
bootcode upgrade, all other system tasks will be halted. This means packets
will not be routed, and all console sessions will not respond during the
upgrade process. Once the process finishes, the system will function as it
did before. This process will take approximately 20 seconds. DO NOT REMOVE
COMPACT FLASH DURING THIS OPERATION!!
Do you want to proceed? [yes/no]y
WARNING!! A bootcode upgrade has been initiated. Your session will become
nonresponsive for the duration of the upgrade (approx. 20 seconds). A message
will be sent when the upgrade is completed.
Bootcode upgrade process done. Your session should function normally.
Reading 318189 bytes of code, stand by...
Image is compressed, inflating......................................
Verifying image
Erasing boot sector
Programming boot sector
Success!!!
5991-2114
Specifies the memory location for the file to copy as compact flash memory.
Specifies the memory location for the file to copy as flash memory.
Specifies the name of the source file to copy.
Specifies the destination memory location for the file copy as the Boot ROM.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
67