HP ProCurve 7102dl Reference Manual page 387

SROS Command Line Interface Reference Guide
ip default-gateway <ip address>
Use the ip default-gateway command to specify a default gateway if (and only if) IP routing is NOT
enabled on the unit. Use the ip route command to add a default route to the route table when using IP
routing functionality. See ip route <ip address> <subnet mask> [<interface or ip address> | null 0]
<administrative distance> on page 438 for more information.
Syntax Description
<ip address>
Default Values
By default, there is no configured default-gateway.
Functional Notes
Only use the ip default-gateway when IP routing is disabled on the router. For all other cases, use the
ip route 0.0.0.0 0.0.0.0 <ip address> command.
Usage Examples
The following example disables IP routing and configures a default gateway for 192.22.71.50:
ProCurve(config)#no ip routing
ProCurve(config)#ip default gateway 192.22.71.50
5991-2114
Specifies the default gateway IP address in the form of dotted decimal notation
(example: 192.22.71.50).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
385