HP ProCurve 7102dl Reference Manual page 111

SROS Command Line Interface Reference Guide
debug ip icmp [send | recv]
Use the debug ip icmp command to show all ICMP messages as they come into the router or are
originated by the router. If an optional keyword (send or recv) is not used, all results are displayed. Debug
messages are displayed (real-time) to the terminal (or Telnet) screen. Use the no form of this command to
disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
send
recv
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates the debug ip icmp send and receive messages for the SROS:
ProCurve>enable
ProCurve#debug ip icmp
ICMP SEND: From (0.0.0.0) to (172.22.14.229) Type=8 Code=0 Length=72 Details:echo request
ICMP RECV: From (172.22.14.229) to (10.100.23.19) Type=0 Code=0 Length=72 Details:echo reply
ICMP SEND: From (0.0.0.0) to (172.22.14.229) Type=8 Code=0 Length=72 Details:echo request
ICMP RECV: From (172.22.14.229) to (10.100.23.19) Type=0 Code=0 Length=72 Details:echo reply
ICMP RECV: From (172.22.255.200) to (10.100.23.19) Type=11 Code=0 Length=36 Details:TTL equals 0
during transit
ICMP RECV: From (172.22.14.229) to (10.100.23.19) Type=3 Code=3 Length=36 Details:port
unreachable
ICMP RECV: From (172.22.14.229) to (10.100.23.19) Type=3 Code=3 Length=36 Details:port
unreachable
5991-2114
Optional keyword which allows you to only display ICMP messages sent by the router.
Optional keyword which allows you to only display ICMP messages received by the
router.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
109