Isdn [Spid 1 | Spid 2] <Spid String> <Ldn - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
isdn [spid 1 | spid 2] <spid string> <LDN>
Use the isdn spid command to specify the Service Profile Identifiers (SPIDs) and the Local Directory
Numbers (LDNs) for the Basic Rate ISDN (BRI) interface. This information should be supplied by your
service provider. Use the no form of this command to remove a configured SPID.
Note
The BRI module requires all incoming calls to be directed to the Local Directory Number
(LDN) associated with the SPID programmed using the isdn spid1 command. All calls to
the LDN associated with SPID 2 will be rejected (unless part of a bonding call).
Syntax Description
<spid string>
<LDN>
Default Values
By default, there are no configured SPIDs or LDNs.
Functional Notes
The SROS does not support "SPID-less" 5ESS signaling. SPIDs are required for all configured BRI
endpoints using 5ESS signaling.
For Euro applications, a SPID is not necessary. Use the isdn ldn command to configure the LDN for Euro
applications.
Usage Examples
The following example defines a SPID of 704 555 1111 0101 and an LDN of 555 1111:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#isdn spid 1 70455511110101 5551111
5991-2114
Specifies the 8- to 14-digit number identifying your BRI line in the Central Office
switch. A SPID is generally created using the area code and phone number
associated with the line and a four-digit suffix. For example, the following SPIDs
may be provided on a BRI line with phone numbers 555-1111 and 555-1112:
SPID1: 701 555 1111 0101
SPID2: 701 555 1112 0101
Optional. Specifies the LDN assigned to the circuit by the service provider. An
LDN programmed using the isdn spid 1 command is automatically associated
with SPID 1. An LDN programmed using the isdn spid 2 command is
automatically associated with SPID 2. The LDN is the number used by remote
callers to dial into the ISDN circuit. Inbound calls are not accepted on interfaces
without programmed LDNs. LDNs can also be entered using the isdn ldn
command. The isdn spid and isdn ldn commands overwrite the existing
programmed LDN; therefore the last LDN programming entered takes
precedence.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
584