HP ProCurve 7102dl Reference Manual page 776

SROS Command Line Interface Reference Guide
max-reserved-bandwidth <percent>
Use the max-reserved-bandwidth command to specify the percentage of interface bandwidth reserved for
use in user-defined (priority or class-based) queues. The remainder of the interface bandwidth is reserved
for system critical traffic and is not available to user-defined queues. Use the no form of this command to
restore the default value.
Caution
Reserving a portion of the interface bandwidth for system critical traffic is necessary for
proper operation. Specifying the entire interface bandwidth for use in user-defined queues
can cause undesirable operation.
Syntax Description
<percent>
Default Values
By default, max-reserved-bandwidth is set to 75 which reserves 25 percent of the interface bandwidth for
system critical traffic.
Usage Examples
The following example specifies 85 percent of the bandwidth on the atm 1.1 interface to be available for
use in user-defined queues:
(config)#interface atm 1.1
(config-atm 1.1)#max-reserved-bandwidth 85
5991-2114
Specifies the percentage of interface bandwidth to make available for
user-defined (priority or class-based) queues. Enter an integer 1 to 100.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
ATM Sub-Interface Config Command Set
774