HP ProCurve 7102dl Reference Manual page 583

SROS Command Line Interface Reference Guide
bonding txnull-timer <seconds>
Use the bonding txnull-timer command to specify the value (in seconds) for the answering endpoint
negotiation timeout. Use the no form of this command to return to the default value.
Syntax Description
<seconds>
Default Values
By default, the bonding txnull-timer value is set to 10 seconds.
Functional Notes
Specifies the length of time the answering endpoint attempts to detect the bonding negotiation pattern from
the originating endpoint before deciding the bonding call has failed. It may be necessary to shorten this
timer if the DTE equipment using the bonding module also has timer constraints for completing
non-bonding parameter negotiation.
Usage Examples
The following example defines a bonding txnull-timer value of 8 seconds:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#bonding txnull-timer 8
5991-2114
Specifies the number of seconds the endpoint waits to detect the bonding
negotiation frame pattern from the originating endpoint (after answering a call)
before considering the bonding negotiation a failure.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
581