Interface Configuration Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
G.703 I
NTERFACE
To activate the G.703 Interface Configuration mode, enter the interface e1 command (and specify the
G.703 port) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface e1 1/2
ProCurve(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text"> on page 1430
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
end on page 1436
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
coding [ami | hdb3]
framing [crc4] on page 680
loopback network [line | payload]
snmp trap link-status
test-pattern [ones | zeros]
ts16 on page 684
5991-2114
C
ONFIGURATION
on page 1434
on page 679
on page 681
on page 682
on page 683
© Copyright 2007 Hewlett-Packard Development Company, L.P.
G.703 Interface Configuration Command set
C
OMMAND SET
on page 1431
678