HP ProCurve 7102dl Reference Manual page 714

SROS Command Line Interface Reference Guide
tdm-group <group number> timeslots <1-24> speed [56 | 64]
Use the tdm-group command to create a group of contiguous DS0s on this interface to be used during the
bind process. See bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port> on
page 1431 for related information.
Caution
Changing tdm-group settings could result in service interruption.
Syntax Description
<group number>
timeslots <1-24>
speed [56 l 64]
Default Values
By default, there are no configured TDM group.
Usage Examples
The following example creates a TDM group (labeled 5) of 10 DS0s at 64 kbps each:
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#tdm-group 5 timeslots 1-10 speed 64
5991-2114
Identifies the created tdm-group by numerical label (valid range: 1 to 255).
Specifies the DS0s to be used in the TDM group. This can be entered as a single
number representing one of the 24 T1 channel timeslots or as a contiguous group
of DS0s. (For example, 1-10 specifies the first 10 channels of the T1.)
Optional. Specifies the individual DS0 rate on the T1 interface to be 56 or 64 kbps.
The default speed is 64 kbps. 56 kbps operation is not available on all T1 interfaces.
Refer to the Quick Start Guide provided with your T1 module to determine whether
56 kbps is valid.
© Copyright 2006 Hewlett-Packard Development Company, L.P.
T1 Interface Configuration Command Set
712