HP ProCurve 7102dl Reference Manual page 838

SROS Command Line Interface Reference Guide
idle-timeout <seconds>
Use the idle-timeout command to set the amount of time the interface link/bundle will remain up in the
absence of interesting traffic. Interesting traffic and direction logic are set using the match-interesting
commands. Refer to match-interesting [list <acl name> | reverse list <acl name>] [in | out] on page 861
for more information. Use the no form of this command to restore the default values.
Syntax Description
<seconds>
Default Values
By default, idle-timeout is set to 120 seconds.
Usage Examples
The following example configures demand interface 1 to time out after 360 seconds:
ProCurve(config)#interface demand 1
ProCurve(config-demand 1)#idle-timeout 360
5991-2114
Specifies the number of seconds the interface will remain up in the absence of
interesting traffic. Range is 1 to 2,147,483.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Demand Interface Configuration Command Set
836