Atm Sub-Interface Config Command Set - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide
ATM S -I
UB NTERFACE
To activate the ATM Interface Configuration mode, enter the interface atm command (and specify a
sub-interface) at the Global Configuration mode prompt. For example:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#interface atm 1.1
ProCurve(config-atm 1.1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
bind <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
description <text>
do on page 1435
exit on page 1437
ping <address> on page 1438
shutdown on page 1442
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
atm routed-bridged ip
backup commands
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dynamic-dns on page 741
encapsulation [aal5mux ip | aal5mux ppp | aal5snap]
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on page 746
max-reserved-bandwidth <percent> on page 774
mtu <size> on page 775
oam-pvc managed <frequency>
oam retry <up-count> <down-count> <retry-frequency>
pvc <VPI/VCI> on page 778
qos-policy out <mapname>
spanning-tree commands
5991-2114
C
ONFIG
on page 1434
on page 718
on page 719
begin on page 720
on page 737
on page 738
on page 739
on page 744
on page 745
on page 776
on page 779
begin on page 781
© Copyright 2006 Hewlett-Packard Development Company, L.P.

ATM Sub-Interface Config Command Set

C S
OMMAND ET
on page 743
on page 777
on page 1431
717