HP ProCurve 7102dl Reference Manual page 993

SROS Command Line Interface Reference Guide
bridge-group <group#>
Use the bridge-group command to assign an interface to the specified bridge group. Use the no form of
this command to remove the interface from the bridge group.
Syntax Description
<group#>
Default Values
By default, there are no configured bridge groups.
Functional Notes
A bridged network can provide excellent traffic management to reduce collisions and limit the amount of
bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can
be bridged (Ethernet to T1 bridge, Ethernet to Frame Relay sub-interface, etc.).
Usage Examples
The following example assigns the HDLC interface labeled 1 to bridge-group 1:
ProCurve(config)#interface hdlc 1
ProCurve(config-hdlc 1)#bridge-group 1
5991-2114
Specifies bridge group number (1 to 255) specified using the bridge-group
command.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
HDLC Command Set
991