HP ProCurve 7102dl Reference Manual page 217

SROS Command Line Interface Reference Guide
show ip interfaces [<interface> | brief]
Use the show ip interfaces command to display the status information for all IP interfaces (or a specific
interface).
Note
To view secondary IP addresses, use the show running-config command.
Syntax Description
<interface>
brief
Default Values
No default value necessary for this command.
Usage Examples
The following is a sample output of the show ip interfaces command:
ProCurve>enable
ProCurve#show ip interfaces
eth 0/1 is UP, line protocol is UP
Ip address is 10.10.10.1
Netmask is 255.255.255.0
MTU is 1500
Fastcaching is Enabled
RIP Authentication is Disabled
RIP Tx uses global version value
RIP Rx uses global version value
5991-2114
Optional. Displays status information for a specific interface. If no interface is entered,
status information for all interfaces is displayed. Type show ip interfaces ? for a
complete list of applicable interfaces.
Use this optional keyword to display an abbreviated version of interface statistics
for all IP interfaces.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
215