HP ProCurve 7102dl Reference Manual page 98

SROS Command Line Interface Reference Guide
debug frame-relay [events | llc2 | lmi]
Use the debug frame-relay command to activate debug messages associated with the Frame Relay
operation. Debug messages are displayed (real-time) to the terminal (or Telnet) screen. Use the no form of
this command to disable the debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
events
llc2
lmi
Default Values
By default, all debug messages in the SROS are disabled.
Functional Notes
The debug frame-relay command activates debug messages to aid in the troubleshooting of Frame Relay
links.
Usage Examples
The following example activates all possible debug messages associated with Frame Relay operation:
ProCurve>enable
ProCurve#debug frame-relay events
ProCurve#debug frame-relay llc2
ProCurve#debug frame-relay lmi
5991-2114
Activates debug messages for generic Frame Relay events (such as Frame Relay
interface state).
Activates debug messages for the logical link control layer.
Activates debug messages for the local management interface (such as DLCI
status signaling state, etc.).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
96