HP ProCurve 7102dl Reference Manual page 423

SROS Command Line Interface Reference Guide
ip load-sharing [per-destination | per-packet]
Use the ip load-sharing command to configure whether parallel routes in the route table are used to
load-share forwarded packets. If this command is disabled, the route table uses a single "best" route for a
given subnet. If this command is enabled, the route table can use multiple "best" routes and alternate
between them.
Syntax Description
per-destination
per-packet
Default Values
By default, ip load-sharing is disabled.
Usage Examples
The following example turns on load-sharing per destination:
ProCurve(config)#ip load-sharing per-destination
The following example disables load-sharing:
ProCurve(config)#no ip load-sharing
5991-2114
Specifies that the route used for forwarding a packet be based on a hash of the
source and destination IP address in the packet.
Specifies that each forwarding route lookup rotates through all the parallel "best"
routes. (Parallel routes are defined as routes to the same subnet with the same
metrics that only differ by their next hop address.)
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
421