SROS Command Line Interface Reference Guide
show ip arp [realtime]
Use the show ip arp command to display the Address Resolution Protocol (ARP) table.
Syntax Description
realtime
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the terminal length command; refer to
Usage Examples
The following is a sample output of the show ip arp command:
ProCurve>enable
ProCurve#show ip arp
ADDRESS
TTL (min)
192.168.30.36
13
192.168.30.253
17
5991-2114
Displays full-screen output in real-time. See the Functional Notes below for more
information.
MAC ADDRESS
00:E0:7D:88:1A:B9
02:60:8C:DD:0A:CE
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
terminal length <lines>
LAST UPDATED (min)
4260
4264
on page 294).
198