HP ProCurve 7102dl Reference Manual page 86

SROS Command Line Interface Reference Guide
debug atm oam
Use the debug atm oam command to display Operation, Administration, and Maintenance (OAM) packets
for an ATM virtual circuit descriptor (VCD). Debug messages are displayed (real-time) to the terminal (or
Telnet) screen. Use the no form of this command to disable debug messages. Variations of this command
include the following:
debug atm oam <vcd>
debug atm oam <vcd> loopback [end-to-end | segment]
debug atm oam <vcd> loopback [end-to-end | segment] <LLID>
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
<vcd>
loopback
end-to-end
segment
<LLID>
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates ATM OAM debug messages for VCD 1:
ProCurve>enable
ProCurve#debug atm oam 1
5991-2114
Shows OAM packets for a specific VCD.
Configures an OAM loopback.
Configures an end-to-end OAM loopback.
Configures a segment loopback.
Specifies 16-byte OAM loopback location ID (LLID).
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
84