HP ProCurve 7102dl Reference Manual page 926

Secure router sros command line interface

Hide thumbs Also See for ProCurve 7102dl:

Table of Contents

SROS Command Line Interface Reference Guide

Frame Relay Sub-Interface Config Command Set

frame-relay bc <committed burst value>

Use the frame-relay bc command to set the b

(committed burst) value for a Frame Relay sublink. The

value is in bits. Use the no form of this command to return to default.

Syntax Description

Enter the committed burst value (in bits) for the sublink.

Default Values

By default, the committed burst value is set to 0 (no limit).

Functional Notes

The time interval is always one second, so this can also be considered bits per second. Shaping is

performed on a sliding one-second window to make maximum use of configured bandwidth. Note that

when both b c and b e are non-zero, shaping is performed on the virtual circuit. The circuit is limited to the

sum of b c and b e , and it is recommended that the sum always be greater than 8000.

Usage Examples

The following example configures sublink fr 1.16 with a committed burst value of 128000 bits:

ProCurve(config)#interface frame-relay 1.16

ProCurve(config-fr 1.16)#frame-relay bc 128000

Chapters

Table of Contents