Loopback Network [B1 | B2 | Both] - HP ProCurve 7102dl Reference Manual

SROS Command Line Interface Reference Guide

loopback network [b1 | b2 | both]

Use the loopback network command to enable a loopback of the interface (towards the network). Use the
no form of this command to disable the loopback.
Syntax Description
b1
b2
both
Default Values
No default necessary for this command.
Usage Examples
The following example enables a b2 loopback of the bri 1/2 interface and disables the loopback:
ProCurve(config)#interface bri 1/2
ProCurve(config-bri 1/2)#loopback network b2
ProCurve(config-bri 1/2)#no loopback network b2
5991-2114
Loops the data on B1 back towards the network. A B1 loopback does not disrupt
D channel signaling.
Loops the data on B2 back towards the network. A B2 loopback does not disrupt
D channel signaling.
Loops the data on B1 and B2 back towards the network, but does not disrupt
D channel signaling.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
BRI Interface Configuration Command set
587