HP ProCurve 7102dl Reference Manual page 121

SROS Command Line Interface Reference Guide
debug ip pim-sparse packets [in | out] <interface> <interface id>
Use the debug ip pim-sparse packets command to display protocol-independent multicast (PIM) sparse
mode packet information. Debug messages are displayed (real-time) to the terminal (or Telnet) screen. Use
the no form of this command to disable debug messages.
Note
Turning on a large amount of debug information can adversely affect the performance of
your unit.
Syntax Description
in
out
<interface>
<interface id>
Default Values
By default, all debug messages in the SROS are disabled.
Usage Examples
The following example activates all PIM sparse packet messages (both inbound and outbound):
ProCurve>enable
ProCurve#debug ip pim-sparse packets
5991-2114
Displays messages for inbound PIM sparse packets
Displays messages for outbound PIM sparse packets.
Specifies specific interface. Type debug ip pim-sparse packets [in | out]
interface ? for a list of valid interfaces.
Specifies a valid interface ID.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
119