HP ProCurve 7102dl Reference Manual page 672

SROS Command Line Interface Reference Guide
spanning-tree bpdufilter [enable | disable]
Use the spanning-tree bpdufilter command to enable or disable the bpdufilter on a specific interface.
This setting overrides the related global setting. Use the no version of the command to return to the default
setting.
Syntax Description
enable
disable
Default Values
By default, this setting is disabled.
Functional Notes
The bpdufilter blocks any BPDUs from being transmitted and received on an interface.
Usage Examples
The following example enables the bpdufilter on the interface eth 0/1:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#spanning-tree bpdufilter enable
The bpdufilter can be disabled on the eth 0/1 by issuing the following commands:
ProCurve(config)#interface eth 0/1
ProCurve(config-eth 0/1)#spanning-tree bpdufilter disable
5991-2114
Enables bpdufilter for this interface.
Disables bpdufilter for this interface.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Ethernet Interface Configuration Command Set
670