HP ProCurve 7102dl Reference Manual page 712

SROS Command Line Interface Reference Guide T1 Interface Configuration Command Set
snmp trap line-status
Use the snmp trap line-status command to control the Simple Network Management Protocol (SNMP)
variable dsx1LineStatusChangeTrapEnable (RFC2495) to enable (or disable) the interface to send SNMP
traps when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the dsx1LineStatusChangeTrapEnable OID is set to enabled for all interfaces except virtual
Frame Relay Interfaces.
Functional Notes
The snmp trap line-status command is used to control the RFC2495 dsx1LineStatusChangeTrapEnable
OID (OID number 1.3.6.1.2.1.10.18.6.1.17.0).
Usage Examples
The following example disables the line-status trap on the T1 interface:
ProCurve(config)#interface t1 1/1
ProCurve(config-t1 1/1)#no snmp trap line-status
5991-2114 © Copyright 2006 Hewlett-Packard Development Company, L.P. 710