HP ProCurve 7102dl Reference Manual page 258

SROS Command Line Interface Reference Guide
show probe
Use the show probe command to display probe configuration and statistics. Refer to Network Monitor
Probe Command Set on page 1330 for information on configuring probe objects. Variations of this
command include the following:
show probe
show probe <name>
show probe <name> realtime
Syntax Description
<name>
realtime
Default Values
No default value necessary for this command.
Functional Notes
A probe must be created first using the probe command. Issuing the shutdown command at the probe
configuration prompt will disable a probe, causing it to cease traffic generation. While a probe is shutdown,
it will not fail.
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
page 294).
Usage Examples
The following is a sample output of the show probe probe_A command:
ProCurve>enable
ProCurve#show probe probe_A
Current State: PASS Admin. Status: DOWN
Type: ICMP Echo Period: 30 sec Timeout: 500 msec
Hostname: www.procurve.com
Tracked by: track_1
Tests Run: 121 Failed: 0
Time in current state: 25 days 2 hours, 34 minutes, 32 seconds
5991-2114
Optional. Displays configuration and statistics for a specific probe.
Optional. Displays full-screen output in real time. Refer to the Functional
Notes below for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
terminal length <lines>
on
256