HP ProCurve 7102dl Reference Manual page 15

SROS Command Line Interface Reference Guide Basic Mode Command Set
enable
Use the enable command (at the Basic Command mode prompt) to enter the Enable Command mode. Use
the disable command to exit the Enable Command mode.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Functional Notes
The Enable Command mode provides access to operating and configuration parameters and should be
password protected to prevent unauthorized use. Use the enable password command (found in the Global
Configuration mode) to specify an Enable Command mode password. If the password is set, access to the
Enable Commands (and all other "privileged" commands) is only granted when the correct password is entered.
crypto ca authenticate <name>
Refer to on page 337 for more information.
Usage Examples
The following example enters the Enable Command mode and defines an Enable Command mode password:
ProCurve>enable
ProCurve#configure terminal
ProCurve(config)#enable password password
At the next login, the following sequence must occur:
ProCurve>enable
Password: ******
ProCurve#
5991-2114 © Copyright 2007 Hewlett-Packard Development Company, L.P. 13