HP ProCurve 7102dl Reference Manual page 240

SROS Command Line Interface Reference Guide
show ip route [connected | ospf | rip | static | table | bgp | summary |
summary realtime | <ip address> <subnet>]
Use the show ip route command to display the contents of the IP route table.
Syntax Description
connected
ospf
rip
static
table
bgp
summary
summary realtime
<ip address><subnet> Displays only the IP routes to destinations within the given address and subnet.
Default Values
No default value necessary for this command.
Functional Notes
Use the realtime argument for this command to display full-screen output in real-time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit reatime
mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the information
will truncate at the bottom of the screen. In order to maximize the amount of data displayed, increase the
terminal length (using the terminal length command; refer to
5991-2114
Optional. Displays only the IP routes for directly connected networks.
Optional. Displays only the IP routes associated with OSPF.
Optional. Displays only the IP routes that were dynamically learned through RIP.
Optional. Displays only the IP routes that were statically entered.
Optional. Displays a condensed version of the IP route table.
Optional. Displays only the IP routes associated with BGP.
Optional. Displays a summary of all IP route information.
Optional. Displays full-screen output in realtime. See the Functional Notes below
for more information.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Enable Mode Command Set
terminal length <lines>
on page 294).
238