HP ProCurve 7102dl Reference Manual page 481

SROS Command Line Interface Reference Guide
logging forwarding source-interface
Use the logging forwarding source-interface command to configure the specified interface's IP address
as the source IP address for the syslog server to use when logging events. Use the no form of this command
if you do not wish to override the normal source IP address.
Syntax Description
<interface>
Default Values
No default value is necessary for this command.
Functional Notes
This command allows you to override the sender field in the IP packet. If you have multiple interfaces in
your unit, changing the sender tells the receiver where to send replies. This functionality can also be used
to allow packets to get through firewalls that would normally block the flow.
Usage Examples
configures the unit to use the loopback 1 interface as the source IP for event log traffic:
ProCurve(config)#logging forwarding source-interface loopback 1
5991-2114
Specifies the interface to be used as the source IP address for event log traffic.
Type logging forwarding source-interface ? for a list of valid interface types.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Global Configuration Mode Command Set
479