HP ProCurve 7102dl Reference Manual page 965

SROS Command Line Interface Reference Guide
spanning-tree bpdufilter [enable | disable]
Use the spanning-tree bpdufilter command to block BPDUs from being transmitted and received on this
interface. To return to the default value, use the no form of this command.
Syntax Description
enable
disable
Default Values
By default, this command is set to disable.
Functional Notes
The purpose of this command is to remove a port from participation in the spanning tree. This might be
beneficial while debugging a network setup. It normally should not be used in a live network.
Usage Examples
The following example enables the BPDU filter on the interface:
ProCurve(config)#interface frame-relay 1.16
ProCurve(config-fr 1.16)#spanning-tree bpdufilter enable
5991-2114
Enables the BPDU filter.
Disables the BPDU filter.
© Copyright 2007 Hewlett-Packard Development Company, L.P.
Frame Relay Sub-Interface Config Command Set
963